Watch the revolutionary new SwiftCarb RampMill in Titanium
Here's the full six minute video of the revolutionary new SwiftCarb RampMill create multiple pockets a full one inch deep in Titanium 6al4v at a serfice footage rate of 550 sfm!
Thursday, 24 June 2010 10:26
Watch the revolutionary new SwiftCarb RampMill in Titanium
Watch a shortened version of the revolutionary new SwiftCarb RampMill create multiple pockets a full one inch deep in Titanium 6al4v at a serfice footage rate of 550 sfm!
Friday, 13 November 2009 17:03
SwiftCarb and Truemill achieve incredible production increases
The combination of the Swiftcarb Ramp and Run end mill and the Truemill cutter path, results in dropping the cycle time for this 5083 armor plating aluminum part, from 50+ minutes down to 6 minutes. The Swiftcarb end mill ramps to the bottom of the part at incredible speeds. This tool is the new RampMill TM from Swiftcarb, it is not an end mill.
Friday, 13 November 2009 16:59
The new SwiftCarb Rampmill in various materials
This video shows the new SwiftCarb Patent Pending Coolant Through RampMill in several applications, mostly in titanium.
Tuesday, 18 August 2009 13:26
Swiftcarb Ramp and Run end mill with Trumill cutter path milling 4340 at 260IPM
This video shows a SwiftCarb ramp and run endmill milling 4340 at 260 inches per minute.
